5 WAYS TO RETURN A WET CELL PHONE TO ITS ACTIVE FORM AND SAVE SOME CASH

I have come to discover that so many cell phone users find it difficult to restore back the working ability of their cell phones when it comes in contact with water, at times when this happens so many users discard the phone because they lack the basic skill to re-store the phone to it's normal form. this articles explains five ways which anyone can adopt to put back a soaked phone to its best active form.

1. UNSCREW PARTS AND ACCESSORIES: the first thing you do when your phone is wet is to lose the parts and accessories in-order to expose the whole parts to air, this can be done firstly by manually opening the battery casing, remove the enclose battery and unscrewing the inner part to allow air into the motherboard. some users see it as a difficult task whereas it is not, with some small screwdriver you can be able to do this on your own.

2. EXPOSE ALL PARTS TO HEAT: After unscrewing the phone parts, there is need to expose the parts to heat, the reason being that there could be some moisture hidden in some parts where air cannot flow in, and if heat is not apply, this moisture could allow current flow to bridge any of the components and consequently damage them. so you can expose all the parts to heat by inserting an electric bulb in a box and putting all these parts inside the box, but make sure the parts are some distance away from the bulb, after which you can then put on the bulb and leave the parts for an hour or two. after this period, the parts and components must have been very dry thereby returning them back to their normal form.

3. ENSURE THAT ALL COMPONENTS ARE WELL SOLDERED: Some people ignorantly abandon their cell phone believing it cannot work again without knowing that one or more of the components has lost contact with the circuit, when the cell phone comes in contact with water, this could break the contact of any of the components from the circuit, so to ensure that the circuit is complete, each of the component parts must be check properly, you can use a digital voltmeter to check this, and if any open circuit is detected, a soldering iron can be used to solder that part.

4. CLEAN THE EARPIECE: Some phone can lose their sound effect when there are tiny objects in the earpiece that can interfare with the magnetic field in that part, so to ensure that this part is free from unwanted elements and also free from rusting, then this part should be clean gently with a very small white handkerchief, this would put the earpiece back in good shape.

5. SCREW BACK PARTS AND ACCESSORIES: After carrying out the above steps, there is need to properly screw back all the losen parts, this can be done by following the steps outlined in the phone manual, and fixing the accessories in the appropriate place, after doing this, you can switch on the phone and surprisingly your cell phone will definitely work well again.

All the above steps are neither time consuming nor stressful, you can be doing something else while the phone is being dried, I'm very optimistic that if the steps above are applied as explained, you need not go to a phone repairer to repair your wet phone anymore. indirectly, you would have saved yourself some cash in your bank account.

there is something you can also do to enjoy your cell phone, if you are keen to know that kindly visit the link below
www.satelitepcbox.blogspot.com